Last post by RV BREEZE -
HELP I CANT FIND ANYONE TO REPAIR OR EVEN LOOK AT MY FRIDGE. The control board on my whirlpool refrigerator does not work so I can not adjust the temp of the fridge. The fridge works but t It’s not really cold. I bought a new control board and put it in and still no joy didn’t come on.
I CANT FIND ANY SERVICE GOR IT NONE.. I cant even find anyone to install another one if k buy one. Don’t know where yo turn. Any advice anyone?
Last post by jvoiss1953 -
Bought my Entegra Ethos in January, 2024. It’s on the Ram Promaster 3500 chassis and no problems with the chassis. Initially used it for day outings and all was well. Received the recall notice on the Renogy battery in April and ran through the tests but didn’t have any of the issues warned about in the recall. Went on the first multi day trip recently. After three days of all working as it should, Renogy battery is no longer charging while driving. Had previously charged perfectly while driving, but no more. Still charged up when connected to 30 amp shore power. Upon returning home, noticed an imbalance in the cell voltages so ran the process to correct and recalibrate. Also completely shut down the battery and then restarted as some posts said that had solved recharging while driving issue. Today put on 60 miles but still no battery charging while driving. Started at 92% and ended at about 84% SOC. Only current draw was frig and brief use of water pump. Wanted to use the microwave so switched the inverter on…… it would not turn on, tried couple times. So non-functioning converter my latest problem.
Last post by Shadow_RC -
My wife and I are looking at an Esteem 31F. Does anyone have one and if so have there been any issues that you have had that you would share with us?
Last post by Comrie Coltharp -
AGM batteries are not a good choice, we are in the era of low prices for lithium batteries, and I am looking into installation options for And I can go completely off the grid.
Last post by AVCM -
I have a 2021 Odyssey 24B and came across this Service Bulletin SRP 22-044 from March 2022. It talks about the controller and inspecting it to ensure it is an 8 Amp rated controller and should have a 8 Amp logo/sticker. Plus the Bulletin discusses slide proper alignment. My controller does not have the 8 Amp sticker. System works, no fault when retracted, but I do get a fault when extended of # 2 slide motor short circuit. But it works just fine. Seeking feedback.
